Structural Characteristics and Advantages of Biteman Modular-units Adsorption Dryer




At present, the existing compressed air purification equipment mainly is refrigeration dryer and adsorption dryer, and biteman modular-units dryer. the original adsorption dryer exits unstable pressure dew point, big energy consumption equipment, difficult maintenance and repair etc. performance of refrigeration dryer can’t completely reach standard, and it exist a lot of Freon on environmental pollution.


Biteman modular-units adsorption dryer effectively solve all kinds of defects that refrigeration dryer and adsorption dryer exists, dryer performance can stably meet the requirements for various industries on the compressed air quality (-20 ℃ ~ -70 ℃), it not only can reach stable and sustained standard, but also has a low energy consumption, it become world’s leader in the field of compressed air purification.



Structural Features of Modular-Units Dryer:


1. Inlet & outlet buffer chamber structure: forming up and down convection, reasonably distributing air source, eliminating adsorption dead angle, effectively using all adsorbents, reducing the filling amount of adsorbent; intake buffer chamber can also gather moisture, rapidly drain, then reach the effect of "instantaneous desorption".


2. Independent modular-units structure: close and even filling of the adsorbent avoid the hazards of "ditch short circuit phenomenon" and "tunnel effect", meanwhile it become more convenient to replace adsorbent, directly replace modular cartridge. increasing modular units can effectively increase the adsorption area, then achieve a specific pressure dew point, reduce equipment pressure loss.



3. New dual-axis air intake cylinder: low failure rate, more stable operation.



4. Regeneration flow rotor: visual display regeneration flow.



Structural advantages of modular-units dryer:

1.Modular-units dryers is simple structure, fewer parts, and no "diffuser" and "diffusion plate", reducing the occurrence of failure rate;



2. Modular-units adsorption dryer is much lesser adsorbent powder, so it won’t block the muffler, reducing the silencer failure rate when exhaust gas of regeneration, there is no fine particles exhaust gas;



3. Adsorption modular-units adopt method of pre-filled adsorbent, it greatly reduce workload, and achieve the same pressure dew point with new machine after replacing adsorbent.








Biteman modular-units desiccant dryer and high precision filter---which is not only completely solve the water, oil, dust in the compressed air and other issues to provide technical support, and also greatly reduce energy consumption much than traditional purification equipment. heatless models need 5% renewable gas consumption, micro-heat models only need 2% the re-gas consumption, greatly reducing the energy consumption and production costs.

评论

发表评论

此博客中的热门博文

Modern Planning in the Field of Compressed Air

图片
In the past, people only consider the initial investment and operating energy costs such as some simple economic factors, they often overlook the influence pollutants in the compressed air for system when established a compressed air system , thus ignoring the compressed air quality (it can not reach standard will bring huge invisible waste for enterprises), and these losses are often much higher than the high quality purchase and operating costs of purification equipment. Perhaps many companies believe that compressed air equipment just little impact when select ordinary one, but what will actually appear on us? In the 1980s, the industry lagged far behind today, the developed countries put forward ISO8573 standards for the purity of compressed air as for different gas equipment, while it failed to supply the gas equipment standard of compressed air, which caused serious impact, such as shorten the service life, decrease accuracy, increase failure rate, poor quality, and the safet
阅读全文

The Importance of Brand Awareness

图片
Brand is an invisible asset for the enterprise, it’s also the most valuable wealth. in the rapid development of the modern life, the difference become shrinking for product performance, quality, sales service from different enterprises, so the brand will become the main factor to choose products for consumer. "Stupid businessmen sell products, smart businessmen sell brand" This sentence fully illustrates the importance of the brand for the enterprise . therefore, companies should have enough brand awareness, and strive to run the business brand. it is the core content of the product, and brand awareness isn’t all other means of marketing, such as Atlas, Ingersoll Rand, Sullair, Kobelco, etc. these enterprises prefer to brand recognition rather than products identification , and it’s also become the only element of market choice. Brand not only refers to the product quality, but also includes the appearance, technology, function, utility and others, it need long-term accumulat
阅读全文

“Throw a sprat to catch a herring" to get the maximum benefit in a short period

图片
There is a question, why do we establish business? Companies just considering saving cost regardless of construction of enterprises, but it real should need the cost of consumption. later hear a manager says to the subordinate, " I have to find ways to earn back for company spent every penny", perhaps this is a lot of top management staff thought, which is good point for a top manager, then we will be reach the business target to obtain the greatest benefits in a short period.  It is not so easy to realize how to get the maximum benefit in a short period. such as a lot of leading brands seem to be impeccable, while the leading brand's business is far less flexible than some small businesses for imbalanced development of different regional market, much longer product line, and imbalanced development in different products. it is difficult to develop appropriate products and marketing strategy according to local conditions due to consider the national market. I
阅读全文